SS Zenducam Z6 Hardwire Installation
Hardwire Installation of the Zenducam Z6 Device
- The Zenducam Z6 may only be connected to a power source using the supplied cables.
- The camera's cylinder side is where the input power connector is located.
- If using the USB cable as the power source, it must provide 5V DC and at least 2A.
- In order to utilize the Z6 full features such as the Active-Standby mode, the camera must be connected to a constant 12V power source.
See the instructions here to Hard-wire the Zenducam Z6 to the vehicle fuse box.