ZenduMaintenance - Set Asset as Online and Offline

ZenduMaintenance - Set Asset as Online and Offline

This article will demonstrate how to set the asset as online and offline.

Steps

  1. Click on the switch to set the asset online.
  2. Select the user who sets the device online from the drop-down menu.
  3. Select the status of the asset from the drop-down menu such as In production etc. for the particular asset.
  4. Add any additional information if necessary.
  5. Click on ‘OK’ and ‘SAVE’.

 
  1. You can view the online status of the asset on top as shown in the below image


    • Related Articles

    • Unable to assign the asset to offline mode - ZenduMaintenance

      This article illustrates how to turn the asset into an offline mode. If you are unable to put an asset into an offline mode in a normal way, this is a slight blip that can occur with assets on rare occasions. The solution is to change the asset ...

    • Zendu Maintenance – Duplicate assets gets created while changing the asset code

      Issue Whenever you are try to change the asset code it is creates a duplicate asset instead of modifying the original asset's code.  Reason Duplicate assets gets created because because the asset information is getting pulled from the Mygeotab ...

    • ZenduMA - What is a Child asset

      This article explains what is a child asset: A child asset is a sub-asset that is attached, or associated with a another parent asset. Examples of the parent to child asset relationship include, a charger (child) for a laptop (parent), a ...

    • ZenduMaintenance - Run reports

      This article explains how to run report in ZenduMaintenance. Steps       1. Go to the 'Reports' tab       2. Select 'Reports'       3. Enter the keyword on the search tab and select the report required from the list of reports       4. Select the ...

    • ZenduMaintenance - Filter WorkOrder based on status

      This article explains how to filter WorkOrders based on the status in ZenduMaintenance. Steps To view list of Work Order with their statuses,       1. Go to the ‘Maintenance’ tab       2. Click on the ‘Work Order’ tab       3. Select the status that ...