ZenduCAm - Link Geotab unit with the camera unit

ZenduCAm - Link Geotab unit with the camera unit

This article explains how to sync the Geotab unit with the camera unit.

Steps

Please follow the below steps to sync Geotab devices with the camera units.
      1. Login to Geotab
      2. Go to ZenduCAM add-in
      3. Select Admin tab > Devices
      4. Click on Edit




      5. Enter the Geotab serial number in the Geotab Serial Number field
      6. Click on Save
 




    • Related Articles

    • ZenduCAM- Add/Delete groups

      This article will explain how to add, edit and delete groups in ZenduCAM. Steps Adding a Group:       1. Login to the ZenduCAM portal       2. Go to the 'Admin' tab       3. Click on the 'Create Group' button       4. Enter the group name in 'Input ...
    • Setting up reports on ZenduCAM

      This article explains how to set up reports on ZenduCAM, as well as the type of reports available. Steps To set up reports on ZenduCAM       1. Login to "ZenduCAM"       2. Click on "Admin"       3. Select "Scheduled reports" on the left-hand side   ...
    • SW Install - CP4 with 4G Camera

      Before installing your device, please document your device serial number. You will need this information at a later time to verify your installation. After completing the installation, please submit the installation details through the following ...
    • ZenduCAM SW Troubleshooting

      This article explains the multiple methods to troubleshoot the SmartWitness ZenduCAM. Information to Collect Record the information of any hardware that is currently in use: DRID/SERIAL # of the Camera device Vehicle # in which the Camera is ...
    • How to add Geofences to the ZenduCam portal ?

      This article explains how to add Geofences to the ZenduCam portal.  Add Geofences Navigate to the “Admin” tab from the top navigation bar. Select “Geofences” from the side navigation bar. Click “Create Zone”. Provide relevant information for the ...