Power Voltage needed for Camera to be turned on

Power Voltage needed for Camera to be turned on

Power Voltage

All of our camera's need 12 V of Constant power in order to turn on.

If you have less than 12 V of Direct power, please ensure that the device is connected properly.

    • Related Articles

    • Smartwitness Camera Basic troubleshooting steps

      This article explains how to complete basic troubleshooting steps for a SmartWitness camera. Steps Follow below troubleshooting steps:       1. Turn off the ignition.       2. Remove the SD card and re-insert it back       3. Remove the SIM card and ...

    • Z6 Camera Specifications

      Element Description Network data Global band Micro-SD 0.59" x 0.47" x 0.029" (15 x 12 x 0.76mm) WiFi Ability to act as hotspot or connect to WiFi Access Point GPS GPS AGPS Road-facing camera 1080P HD adjustable FOV(D)140° wide-angle camera ...

    • Connect the AI-12 to a Power Source - ZenduCAM Z6 In vehicle Installation

      The Surfsight AI-12 may only be connected to a power source using the supplied cables. The camera's cylinder side is where the input power connector is located. If using the USB cable as the power source, it must provide 5V DC and at least 2A. In ...

    • ZenduCAM SW Troubleshooting

      This article explains the multiple methods to troubleshoot the SmartWitness ZenduCAM. Information to Collect Record the information of any hardware that is currently in use: DRID/SERIAL # of the Camera device Vehicle # in which the Camera is ...

    • SW Install - CP4 with 4G Camera

      Before installing your device, please document your device serial number. You will need this information at a later time to verify your installation. After completing the installation, please submit the installation details through the following ...