Locking sd door on the camera device

This article demonstrates how to lock the sd door and screw it down 

There is a small screw that goes into the SD card sliding door. Basically, once the SD card is being inserted into the CP4 unit and the door is in locked position installers should place this screw in order to keep the door in that position. Sometimes this Torx screw is not being installed along with the vehicle's movement it might cause such impact.

 

• Related Articles

• Close SD door

  Procedure: Please see the below image and ensure that the SD door locking switch is closed.

• Smartwitness Camera Basic troubleshooting steps

  This article explains how to complete basic troubleshooting steps for a SmartWitness camera. Steps Follow below troubleshooting steps:       1. Turn off the ignition.       2. Remove the SD card and re-insert it back       3. Remove the SIM card and ...

• Power Voltage needed for Camera to be turned on

  Power Voltage All of our camera's need 12 V of Constant power in order to turn on. If you have less than 12 V of Direct power, please ensure that the device is connected properly.

• ZenduCAM SW Troubleshooting

  This article explains the multiple methods to troubleshoot the SmartWitness ZenduCAM. Information to Collect Record the information of any hardware that is currently in use: DRID/SERIAL # of the Camera device Vehicle # in which the Camera is ...

• Insert the SIM and SD cards into the dashcam

  Procedure: To install the SIM and SD cards: Use the special screwdriver included in the box when you purchased the dashcam to remove the safety screws that lock it. Insert the SIM and SD cards, as needed NOTE: Only insert a microSIM card. If you ...