SW Install - CP4 with 4G Camera

SW Install - CP4 with 4G Camera

Before installing your device, please document your device serial number. You will need this information at a later time to verify your installation. After completing the installation, please submit the installation details through the following website " http://install.smartwitness.com " 

See Below or   Click Here

    • Related Articles

    • SS Hard-wire the Zenducam Z6 to the Vehicle Fuse Box - In vehicle Installation

      Hard-wiring a dashcam to the vehicle’s fuse box is one of the most common installation methods to power your dashcam. In order to utilize the Zenducam Z6 full features such as active standby, the camera must be connected to a constant 12V power ...

    • Hard-wire the AI-12 to the Vehicle Fuse Box - ZenduCAM Z6 In vehicle Installation

      Hard-wiring a dashcam to the vehicle’s fuse box is one of the most common installation methods to power your dashcam. In order to utilize the AI-12 full features such as active standby, the camera must be connected to a constant 12V power source. ...

    • ZenduCAM SW Troubleshooting

      This article explains the multiple methods to troubleshoot the SmartWitness ZenduCAM. Information to Collect Record the information of any hardware that is currently in use: DRID/SERIAL # of the Camera device Vehicle # in which the Camera is ...

    • Install - CP1 with 3G Camera

      Before installing your device, please document your device serial number. You will need this information at a later time to verify your installation. After completing the installation, please submit the installation details through the following ...

    • SS Zenducam Z6 Hardwire Installation

      Hardwire Installation of the Zenducam Z6 Device The Zenducam Z6 may only be connected to a power source using the supplied cables. The camera's cylinder side is where the input power connector is located. If using the USB cable as the power source, ...